Troubleshooting
Warning
Safe Use and Care
Warranty
Your new POOLRITE Dominator Pump is manufactured to the highest possible standards and most up-to-date technology.
Accordingly the equipment carries the following warranty, should a fault occur due to faulty manufacture or
materials. In the event of a fault covered by warranty occurring, the purchaser must, in the first instance,
contact Poolrite Equipment Pty Ltd or the closest authorised distributor.
POOLRITE warrants that the Dominator Pump will operate effectively for the specified periods subject to the following
conditions:-
1. The warranty covers the Dominator Pump unit, and the original Dominator Pump when they are included in the initial
purchase as a complete unit.
2. The warranty extends to the workmanship and materials used in the manufacture of the unit only. POOLRITE specifically
disclaims any liability for any consequential loss or damage which may result from the use of the Dominator Pump .
3. The Dominator Pump is warranted against manufacturing defects only for a period of 3 years from date of purchase, in
which event POOLRITE shall, as its sole operation, either repair or replace such damage to units delivered to POOLRITE or its
authorised distributor.
4. This warranty extends only to:
(i)
within the borders of Australia and New Zealand
(ii)
Dominator Pump that are installed and maintained strictly in accordance with POOLRITE’s instructions and/or
installed by agents duly authorised by POOLRITE without alterations or modifications of any nature whatsoever.
(iii)
The Dominator Pump returned to the distributor from which it was purchased or to
POOLRITE at the purchaser’s expense.
5. This warranty excludes:
(i)
Damage arising from abnormal use, lack of care, extreme exposure to the elements or chemicals or factors beyond
the control of POOLRITE
(ii)
The POOLRITE warranty supersedes all other warranties whether expressed or implied.
POOLRITE accepts no responsibility for loss, damage or injury to person or property arising from warranty failure of
equipment, or installation of that equipment. Unless with the express authority of POOLRITE any repair or
replacement shall be provided only by POOLRITE or its authorised Distributors and this warranty shall not extend to any
expenditure otherwise incurred.
If the Pump and Motor runs but there is little or no water flow, the following conditions may apply:
Check to see if the
Filter needs cleaning
or is blocked.
Pump is not primed.
Air leaks in suction
lines .
Blockages
Water on ground under
the Pump and Motor
usually indicates a
damaged Pump Shaft
Seal
Pump unable to draw
water from the pool
Refer to
Filter Instruction
Manual.
Re-prime as per
instructions in
“Starting
Pump”.
Check for air bubbles
under Clear Lid and
tighten.
Check Strainer Basket
and Pool Skimmer
Basket are free of
obstruction.
This should be
repaired immediately
or further damage
may occur.
Check Strainer Basket
and Pool Skimmer
Basket are free of
obstruction. If a
blockage is suspected
inside the Pump or
in the Pipework the
advice of your pool
ician should
be sought.
Check power point by plugging in a
portable appliance to ensure power
is available. Also check Fuses and
Main Power Supply Switch
Poolrite Motors incorporate an
Internal Switch that will reset
automatically after the Motor
has cooled.
If a Pump or Pipework blockage is
suspected that is preventing the
motor from rotating, the advice of
your pool service technician should
be sought.
“Burning” smell evident -
replacement
may be required.
T
he Pump Motor is an electrical device and as such should not be disassembled or serviced by anyone other than an authorised Poolrite Service Technician or qualified Elec-
tricial Service Company. This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to
ensure that they can use the appliance safely.
Young children should be supervised to ensure that they do not play with the appliance.
Also, any other problems that cannot be corrected by routine maintenance should be attended to by an experienced Pool Service Technician.
If the motor does not run, the problem could be that:
Power not connected
Overload tripped
Blockage preventing Pump from
rotating.
Motor fused or “burnt out”
union adapter
union adapter
strainer basket
strainer port
suction port
150mm (min)
pump body
discharge port
clear lid
20
70
3
