POOL ROLL ASSEMBLY
1.
First loosen the allen screws on the 2
pre-assembled tubes, and then slide the
inside tube outwards, but do not
completely remove.
At this stage leave the two tubes
connected but loose.
2.
On the other single tube, remove the
screws from the connecting nuts. Keeping
these connecting nuts in their original
channel, line up the tube with the other
tubes and slide together. When the holes
line up with the connecting nuts (which are now inside the tube), loosely secure with
the allen screws which you removed earlier.
3.
When the tubes are connected, and the screws are all connected to the nuts, pull
out the tubes evenly to the required width. This should be the pool width plus a
minimum of 9” either side. Make sure that the tubes are
pulled out evenly either
side of the central tube. Tighten the allen screws.
4.
Fit the tube to the end stands.
5.
Position the completed reel at the pool edge, centrally and square.
