Pontiac 2001 Aztek, Owner'S Manual, Page: 357 / 433

6-30
Your brake master cylinder reservoir is filled with
DOT
-
3 brake fluid. See “Engine Compartment
Overview” in the Index for the location of the reservoir.
There are only two reasons why the brake fluid level in
the reservoir might go down. The first is that the brake
fluid goes down to an acceptable level during normal
brake lining wear. When new linings are put in, the
fluid level goes back up. The other reason is that fluid
is leaking out of the brake system. If it is, you should
have your brake system fixed, since a leak means that
sooner or later your brakes won’t work well, or won’t
work at all.
So, it isn’t a good idea to “top off” your brake fluid.
Adding brake fluid won’t correct a leak. If you add fluid
when your linings are worn, then you’ll have too much
fluid when you get new brake linings. You should add
(or remove) brake fluid, as necessary, only when work is
done on the brake hydraulic system.
CAUTION:
If you have too much brake fluid, it can spill on
the engine. The fluid will burn if the engine is hot
enough. You or others could be burned, and your
vehicle could be damaged. Add brake fluid only
when work is done on the brake hydraulic system.
See “Checking Brake Fluid” in this section.
United States Canada
When your brake fluid falls to a low level, your brake
warning light and the low brake fluid message will come on.
See “Brake System Warning Light” and “Low Brake Fluid
Warning Message” in the Index.