Polytec PSV-500, Hardware Manual

Page: 31 / 109

3-17
3 First Steps
3.4.3 PSV-A-013 System Cabinet
The PSV-A-013 system cabinet is supplied with all system components
assembled and cabled. Unpack the system cabinet as follows:
1. Remove the lashing straps using a suitable tool, e.g. a pair of scissors.
2. Remove the ramp from the top of the packaging and place the ramp in
front of the pallet.
3. Inside the box there is a recess for accessories separated from the other
components by a smaller cardboard box. Find the accessories in the
cardboard box.
4. On this side, undo the screw connections using suitable tools, such as a
pair of pliers.
5. Carefully remove the cardboard ring and take out the accessories.
6. Remove the cardboard box and all the shock-absorbing material.
7. Under the system cabinet there is a box with the documentation for the
measurement system. Remove the cardboard box and keep it for later
use.
8. Remove the square timber with leveling feet from below the system
cabinet. To do so, screw the nut [2] onto the leveling feet with the spanner
provided, turning it counterclockwise upwards until it reaches the nut [1]
(refer to the following figure).
9. Screw the nut [1] clockwise downwards until the system cabinet stands on
the pallet and the square timber can be freely moved.
Figure 3.12: Square timber with leveling foot
10. Remove the square timber from below the system cabinet.
11. Release the locking brakes and move the system cabinet down the ramp
to the desired location.