Ice Maker IM-65L
E&OE
©2018 Polycool
2
Safety
When using electrical appliances, basic safety precautions should always be followed, including the
following:
•
Electric shock/electrocution hazard
- NEVER immerse the electrical cord or appliance body in water.
•
Indoor use only - do not use outdoors.
•
The appliance must be used on flat, level surfaces only.
•
Some surfaces of the appliance may become hot during use (especially the cooling system
components).
•
Allow at least 150mm (6") of clearance around the appliance and do not use the appliance near sources
of heat (ovens etc).
•
Use water that is suitable for drinking only.
•
Do NOT allow water to remain in the appliance after use.
•
Do NOT use mechanical devices or other means to accelerate the defrosting process.
•
Disconnect the appliance from the electrical supply while not in use, when assembling and before
cleaning.
•
Supervision is necessary when using the appliance near children.
•
Do NOT allow children to operate or play with the appliance.
•
Do NOT allow the unit to tilt >45° when being moved or transported, otherwise, damage to the
compressor may result.
•
Do NOT use the unit if it causes a circuit breaker to trip – have it inspected and repaired at an authorised
service centre or by a qualified technician. Never try to replace parts or repair the unit by yourself.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge. All users should have adequate training in
safely operating the product or be under supervision of a person responsible for their safety
•
Do NOT operate the appliance if the electrical cord or plug is damaged.
•
This appliance is for domestic use only.
•
The drainage tube MUST empty into a drain or receptacle that is LOWER than the appliance.
Before First Use
•
Check that the voltage indicated on the rating label corresponds to the mains voltage.
•
Thoroughly clean all parts except the body in warm soapy water, then rinse and dry.
•
Place the appliance where it is to be used, open all covers and allow to stand for a minimum of 2 hours
before connecting to power