3.
Connect the PRI cable into any
PRI
port.
Note:
Only the RealPresence Collaboration Server (RMX) 1800-3 with built-in ISDN module
provides PRI ports, as shown next.
RealPresence Collaboration Server (RMX) 1800-3 rear panel
Installing the RealPresence Collaboration Server
(RMX) 2000
The Polycom RealPresence Collaboration Server 1800/2000/4000 Appliance Edition can be installed in a
rack.
Install RTM ISDN Card on the RealPresence Collaboration Server
(RMX) 2000/4000
If the ISDN option was purchased with your RealPresence Collaboration Server, the ISDN card is shipped
separately and must be manually installed into the rear of the system. It is recommended to install the
ISDN card before the system is placed in a rack.
An RMX Software License is included with the ISDN card and must be registered as part of the Product.
Remove the blank cover from the rear of the RealPresence Collaboration Server
(RMX) 2000
Before you can install an RTM ISDN card into the RealPresence Collaboration Server (RMX) 2000
system, you must remove the blank cover first.
Procedure
To remove the blank cover from the rear of the RealPresence Collaboration Server (RMX) 2000:
1.
Ensure that the power switch/circuit switch on the RealPresence Collaboration Server (RMX) 2000
is turned OFF (O).
2.
Unscrew the captive screws on the rear panel of the RealPresence Collaboration Server (RMX)
2000 that secure the blank panel.
3.
Appliance Edition Installation
Polycom, Inc.
19
