Polycom MGC Administrator, Administrator'S Manual

Page: 322 / 584

Chapter 5 - MCU System Management
5-86
• CIF_RESOLUTION_IN_H323_DUO_VIDEO = YES
Set to YES to enable the declaration of CIF in the content capabilities of
Tandberg H323 Duo Video participants.
• H239 = YES
YES = Enables H239 Calls.
NO = Disables H239 Calls.
•
GW_EPC_H239 = YES
YES = Enables H.239 in gateway calls (if both endpoints support
Content or H.239), with Content/H239 conferences.
NO = Disables gateway calls in Content/H239 conferences.
Section T1-CAS-PARAMETERS
• T1CAS_WINKSTART_TIMER2 = 1
Delay before sending WinkStart for dial-in in T1-CAS party; 0 - 10 (0
means no delay, 10 means 100 ms)
•
DT_PARAMS = 1,300,600,10,1
Defines the general characteristics of the dial tone. Continuous flag,
Frequency 1, Frequency 2, Time tolerance, Tone order
•
DT_CADENCE = 100,300
Define the dial tone's cadence in pairs - t1_on, t1_off, t2_on, t2_off...
•
B_PARAMS = 1,300,600,10,1
Defines the general characteristics of the busy tone. Continuous flag,
Frequency 1, Frequency 2, Time tolerance, Tone order
• B_CADENCE = 100,300
Define the busy tone's cadence in pairs - t1_on, t1_off, t2_on, t2_off...
• FB_PARAMS = 1,300,600,10,1
Defines the general characteristics of the fast busy tone. Continuous flag,
Frequency 1, Frequency 2, Time tolerance, Tone order
• FB_CADENCE = 100,300
Define the fast busy tone's cadence in pairs - t1_on, t1_off, t2_on,
t2_off...
•
ALLOW_T1_CAS_PARTICIPANTS_IN_VIDEO_CONFERENCE =
NO
Set this flag to YES to allow T1-CAS, Audio Only participants to join a
video conference in a unified (mixed media) MCU. In this case, all video