Polycom HDX 9004, Administrator'S Manual, Page: 55 / 194

Monitors and Cameras
3 - 13
3.
Select and configure these settings:
Setting Description
Camera 2 Specifies the camera’s aspect ratio:
• 4:3 — Select if you are using a regular camera.
• 16:9 — Select if you are using a wide-screen camera.
This setting also configures the following cameras to produce
the corresponding video format:
• Polycom PowerCam Plus
• Polycom PowerCam
• Polycom Eagle Eye
• Sony EVI-D100
• Sony BRC-300
Specifies the camera’s format:
• Component YPbPr — Select if the camera is connected
to the Polycom HDX system using a component cable.
• S-Video — Select if the camera is connected to the
Polycom HDX system using an S-Video cable.
• Composite — Select if the camera is connected to the
Polycom HDX system using a composite video cable.
Name Specifies a name and icon for the camera.
Source Specifies whether the camera source is People or Content .
Video sources specified as Content are sent at a higher
resolution and lower frame rate.
Video Quality Specifies Motion or Sharpness for the video input.
• Motion — This setting is for showing people or other
video with motion.
• Sharpness — The picture will be sharp and clear, but
moderate to heavy motion at low call rates can cause
some frames to be dropped. Sharpness is available in
point-to-point H.263 and H.264 calls only.
Detect Camera Detects any supported PTZ camera connected to Polycom
HDX system video input 2 and configures the camera
settings accordingly.