Disable CEC
You can disable CEC in the system web interface.
Procedure
1.
In the system web interface, go to
Audio/Video
>
Monitors
.
2.
Clear the
Enable Consumer Electronics Control
check box.
Enable CEC
You can enable CEC in the system web interface.
Make sure your monitor’s CEC settings are configured correctly (see your monitor’s documentation).
Procedure
1.
In the system web interface, go to
Audio/Video
>
Monitors
.
2.
Select the
Enable Consumer Electronics Control
check box.
Configure General Camera Settings
You can configure settings for cameras connected to your system. The system automatically discovers
your camera model and displays the relevant settings in the system web interface.
See the latest
Release Notes
for specific information about the cameras you can use with your system.
Note:
If you connect an unsupported camera, the system still attempts to show video. Poly can’t
guarantee that the results are optimal or that the available settings are the same as a supported
camera.
Procedure
1.
In the system web interface, go to
Audio/Video
>
Video Inputs
>
General Camera Settings
.
2.
Configure the following settings:
Setting
Description
Allow Other Participants in a Call to Control Your
Camera
Specifies whether the far site can pan, tilt, or zoom
the near-site camera. When you enable this setting,
a user at the far site can control the framing and
angle of the camera for the best view of the near
site. This is also called Far End Camera Control
(FECC).
Configuring Video and Camera Settings
81
