18
POLITEC | INSTALLATION MANUAL - VER.3.1
MANA MW
3.Set DIPs 1-2-3-10 on the RX motherboard to ON.The status LEDs and the display will light up.4.Raise
the gain until all the red and yellow LEDs are on (Gain trimmer - clockwise).
5.If the green LEDs are also on, lower the gain (Gain trimmer - anticlockwise) until only the red and
yellow LEDs are on.
6.Increase the signal level by rotating the RX and TX columns horizontally.An improvement in
alignment will occur when the green LEDs also light up.(Gain trimmer stopped).
7.Reduce the gain again to have only the red and yellow LEDs on.(Gain trimmer - Anticlockwise).
8.Increase the signal level again by rotating the RX and TX columns horizontally and vertically using the
locking screw behind the dish until the maximum possible signal level is obtained.
9.Lower DIPs 1-2-3 and raise 5 and wait a few minutes for signal stabilisation.10.Check that the value
corresponds to that indicated in the table and then lower DIPs 5-10.
N.B.:To check the optimal orientation, press the dish with a finger pointing it towards a specific
direction (right or left) checking if there is an increase in the signal level.
Distance
CAG Value
1-80m
4.5-5.0
80-160m
5.1-6.4
160-250m
6.5-7.3
The lower the CAG value,
the better the alignment