6. Sensor mounting
7
GAPID SENSOR
Placement and installation height
This type of sensor has the optimal sensitivity of a diameter of 5 metres on all types of fences, metal
structures and gates.If the fence is supported by poles about 5 metres apart, position the sensor in the
centre of this distance, so as to place one in each "sector".
However, it is necessary to take into consideration the type of material of the fence since, depending
on whether it is loose mesh, welded or with panels, the material will transmit a different sensitivity.
POLITEC | INSTALLATION MANUAL - VER.2.3
Position the Gapid in the centre of the panel
or the fencing and screw it to the fixing plate
positioned on the other side.Tighten the
screws firmly to prevent the device from
moving.
After calibration and programming, close the device
making sure that the O-ring is well positioned inside
the appropriate compartment and that the protective
cover closes well.
GAPID SENSOR can be connected to the network with
the cable supplied.
The cable must be tied to the fence/gate or on the
surface to be protected.
WARNING:
Product warranty is invalid if there is any hole in the product or any component