Polestar 2 2020, Manual

Page: 473 / 568

Using a puncture
repair kit
The emergency puncture repair kit (TMK
170
) can
be used to seal a puncture. Read through all
instructions prior to use.
Overview
Electrical cable
Air hose
Pressure reducing valve
Protective cap
Label, maximum permitted speed
Bottle holder (orange cap)
Pressure gauge
Sealing fluid bottle
Switch
Connecting
1. Preparations
Set up the warning triangle and activate the
hazard warning lights if a tyre is being
sealed in a trafficked location.
If the puncture was caused by a nail or simi-
lar, allow this to remain in the tyre. It helps to
seal the hole.
2. Detach the decal for maximum permitted
speed that is affixed on one side of the com-
pressor. Affix it visibly on the windscreen as
a reminder to observe the speed limit. You
should not drive faster than 80 km/h
(50 mph) after the emergency tyre repair kit
has been used.
3. Check that the switch is in position 0 (Off),
and locate the electrical cable and the air
hose.
4. Unscrew the orange-coloured cap from the
compressor, and unscrew the cork from the
sealing fluid bottle.
170 Temporary Mobility Kit
>>
Wheels and tyres 473