Polaris RZR PRO XP 2020, Service Manual

Page: 295 / 598

6
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
6.5
DRIVE BELT
BELT REMOVAL
1. Loosen the clamp
q
retaining PVT inlet duct to the
outer clutch cover.
2. Loosen fourteen fasteners
w
that retain the outer
clutch cover. Remove the clutch cover.
NOTICE
Outer cover fasteners are captured fasteners and will
remain in the outer cover when loosened.
3. Maneuver the outer clutch cover outward as shown
below to access the drive belt.
4. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
5. Insert clutch spreader tool
e
into the driven clutch
and turn the tool clockwise to open the sheaves on
the driven clutch.
NOTE
The driven clutch spreader tool is included with the
vehicle’s tool kit
6. Walk the belt out of the driven clutch and drive clutch.
Remove the belt from the vehicle.
BELT INSPECTION
1. Inspect belt for hour glassing (extreme circular wear
in at least one spot and on both sides of the belt).
Hour glassing occurs when the drive train does not
move and the drive clutch engages the belt.
2. Inspect belt for loose cords, missing cogs, cracks,
abrasions, thin spots, or excessive wear. Compare
belt measurements with a new drive belt. Replace if
necessary.
3. Belts with thin spots, burn marks, etc., should be
replaced to eliminate noise, vibration, or erratic PVT
operation. See the Troubleshooting Chart at the end
of this chapter for possible causes.
PVT SYSTEM