9940259 R02 - 2022
RZR
PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
2.13
ENGINE OIL AND FILTER CHANGE
1. Place the vehicle on a level surface and allow the
engine to run, if necessary, two to three minutes until
warm. Stop engine and set parking brake.
2. Clean the area around the drain plug at the bottom of
the oil pan.
WARNING
Personal injury can occur when handling used oil. Hot
oil can cause burns or skin damage.
3. Place a drain pan beneath the oil pan and remove
drain plug
q
.
4. Remove the crush washer and DISCARD.
5. Allow oil to drain completely.
6. Using a clean, dry cloth, clean plug sealing surface
on crankcase.
NOTICE
The sealing surface on the drain plug should be clean
and free of burrs, nicks or scratches.
7. Install NEW crush washer onto the drain plug
q
and
install. Torque to specification.
TORQUE
Oil Drain Plug:
13 ft-lbs (18 Nm)
8. Using oil filter socket
PU-52890
, turn the oil filter
w
counter-clockwise to remove and discard.
9. Lubricate gasket area on new oil filter with a film of
fresh engine oil. Check to make sure the sealing
areas are in good condition.
10. Install a new oil filter and torque to specification.
TORQUE
Oil Filter:
18 in-lbs (2 Nm)
11. Remove cargo box. Fill the sump with oil to the
recommended level through the oil filler access cap
e
on top of the valve cover.
FLUID CAPACITY
Recommended Engine Oil: PS-4 Full Synthetic 5W-
50
or
PS-4 Extreme Full Synthetic 0W-50
Engine Oil Capacity:5.5 qt (5.2 L)
12. Start the engine and let it idle for a minimum of two
minutes. Stop the engine and inspect for leaks.
13. Re-check the oil level on the dipstick
r
after three
minutes and add oil as necessary to bring the level to
the safe zone on the dipstick.
14. Dispose of used oil and oil filter properly.
