9940259 R02 - 2022
RZR
PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
9.29
5. Reverse the procedure to reinstall the shock. Torque
fasteners to specification.
IMPORTANT
Ensure Dynamix equipped models have the harness
properly secured to the shock body.
TORQUE
Front Shock Mounting Bolts ( Top and Bottom):
133 ft-lbs (180 Nm) - Torque bolt side
Rear Shock Mounting Bolts (Top and Bottom):
133 ft-lbs (180 Nm) - Torque bolt side
SHOCK / SPRING REPLACEMENT
1. Remove the shock and note the spring preload
distance (see Spring Adjustment page
.)
2. Loosen the jam nut (if applicable) and adjustment ring
until the spring is loose. If needed, use a spring
compressor to compress the spring far enough to
remove the spring retainer.
3. Remove the spring and spring retainer from the
existing shock and install components onto the new
shock.
4. Install the spring(s) and spring retainer.
NOTICE
The spring retainer gap should be 180° from the end of
the spring upon installation.
5. Tighten the spring adjustment ring to set the preload
distance noted in Step 1.
6. Reinstall the shock onto the vehicle and torque new
fasteners to specification.
