9926813 R04 - 2013-2016
RZR
570 Service Manual
© Copyright Polaris Industries Inc.
8.23
STABILIZER BAR REMOVAL /
INSTALLATION
1.
Remove the cargo box access panel.
2.
Remove the bushing retaining nut (A) from the upper
portion of the stabilizer bar linkage on each side of
the vehicle.
3.
Remove the four fasteners (B) retaining the stabilizer
bar bracket to the frame. Remove the bushing and
bushing brackets from the vehicle.
4.
Remove the stabilizer bar from the vehicle.
NOTE
Rotate the stabilize bar 180 degrees so the linkage hole
(C) is facing rearward to aid in stabilizer bar removal.
5.
Inspect the stabilizer bar for straightness. Inspect the
bushings and replace if needed.
6.
Inspect the rubber bushings on the linkage rod and
replace if needed.
7.
Reverse the procedure for installation.
8.
Torque
the
stabilizer
mounting
nuts
(B)
to
specification.
TORQUE
Stabilizer Mounting Bolt:
18 ft-lb (24 Nm)
9.
Torque the bushing retaining nut (A) on the upper
portion of the stabilizer bar linkage to specification.
TORQUE
Stabilizer Bushing Retaining Nut:
37 ft-lbs (50 Nm)
