Polaris RANGER EV 2015, Service Manual

Page: 113 / 247

5
9926595 R01 - 2015-2016 RANGER EV Service Manual
© Copyright Polaris Industries Inc.
5.7
4. Support U-joint in vise as shown and drive inner yoke
down to remove remaining bearing caps.
5. Force U-joint cross to one side and lift out of inner
yoke.
PROP SHAFT U-JOINT INSTALLATION
1. Install new bearing caps in yoke by hand.
2. Carefully install U-joint cross. Take care not to
dislodge needle bearings upon installation of cross
joint. Tighten vise to force bearing caps inward while
keeping the cross in alignment with the caps.
3. Using a suitable arbor, fully seat bearing cap in one
side. Continually check for free movement of bearing
cross as bearing caps are assembled.
4. Install snap ring to contain bearing cap just installed.
Repeat procedure for other side.
FINAL DRIVE