Polaris RANGER CREW 900 2014, Manual

Page: 78 / 447

3
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.
3.21
COOLING SYSTEM BLEEDING
PROCEDURE
WARNING
Always wear safety glasses and proper shop clothing
when performing the procedures in this manual. Failing
to do so may lead to possible injury or death.
NOTE
If the coolant level is LOW in the radiator, or if there are
leaks in the system, the coolant system will not draw
coolant from the reservoir tank.
1. Allow engine and cooling system to cool down.
CAUTION
Escaping steam can cause burns. Never remove the
pressure cap while the engine is warm or hot. Always
allow the engine to cool before removing the pressure
cap.
2. Remove the hood from the front cab.
3. Remove the recovery bottle cap (A) and fill the bottle
to the MAX line.
4. Remove the pressure cap (B) and add the necessary
amount of Polaris Premium Antifreeze to the radiator
filler neck.
5. Tilt the rear cargo box to the raised position.
6. Remove the upper exhaust heat shield to access the
coolant bleed screw.
7. Open the bleed screw (C) to allow any trapped air to
escape. Close the bleed screw once a steady stream
of coolant begins to drain out.
8. Tighten the bleed screw to specification, top off
coolant and properly install the pressure cap.
TORQUE
Coolant Bleed Screw: 89 ± 9 in-lbs (10 ± 1 Nm)
9. Start the engine and allow it to idle until the coolant
fan has cycled two times.
10. Allow engine and cooling system to completely cool
down (see CAUTION).
11. Remove the pressure cap. Add the necessary
amount of Polaris Premium Antifreeze to the radiator
filler neck.
12. Open the bleed screw to allow any trapped air to
escape. Close the bleed screw once a steady stream
of coolant begins to drain out.
13. Tighten the bleed screw to specification, top off
coolant and properly install the pressure cap.
TORQUE
Coolant Bleed Screw: 89 ± 9 in-lbs (10 ± 1 Nm)
14. Fill the recovery bottle to the MAX line.
15. Reinstall the upper exhaust heat shield.
16. Reinstall the hood.
WATER PUMP REMOVAL
1. Allow engine and cooling system to cool down.
CAUTION
Be sure the engine has cooled and no pressure is built
up in the cooling system before removing the pressure
cap. The coolant may be hot and could cause severe
injury or burns.
ENGINE