Polaris RANGER 500, Owner'S Manual

Page: 117 / 152

BATTERY REMOVAL
WARNING
Improperly connecting or disconnecting battery cables can result in an
explosion and cause serious injury or death. When removing the battery,
always disconnect the negative (black) cable first. When reinstalling the
battery, always connect the negative (black) cable last.
To remove the battery, do the following:
1. Remove the seat (rear seat on CREW 570) to access the battery
compartment.
2. On conventional batteries, remove the battery vent tube.
3. Disconnect the black (-) battery cable first. Disconnect the red (+) battery
cable last.
4. Remove the battery hold-down strap.
5. Lift the battery out of the vehicle. Be careful not to tip a conventional battery
sideways, which could spill electrolyte.
NOTICE
If electrolyte spills, immediately wash it off with a solution of one tablespoon
baking soda and one cup water to prevent damage to the vehicle.
BATTERY INSTALLATION
Using a new battery that has not been fully charged can damage the battery and
result in a shorter life. It can also hinder vehicle performance. Follow instructions
in the Battery Charging (Conventional Battery) section before installing the
battery.
An optional extreme use battery may be available for your model. If the
performance of the factory-installed battery is inadequate due to operation in
extreme cold or due to extended use of multiple electrical accessories, your
dealer can assist. Your dealer can provide any installation procedures that may
differ for an extreme use battery.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder.
115
MAINTENANCE