Polaris RANGER 1000 2020, Service Manual

Page: 575 / 610

12
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
12.21
SPEED SENSOR TESTING
Special Tools Required:
Static Timing Light Harness (
2871745 )
Hall Sensor Probe Harness ( 2460761 )
1. Disconnect the 3 wire harness from the speed
sensor
and remove the sensor from the
transmission.
2. Connect the wires from the Static Timing Light
Harness to the sensor 3 pin connector using the Hall
Sensor Probe Harness (
2460761 ).
3. Pass a screwdriver back and forth in front of the
sensor tip.
4. Be sure connections are good and 9V battery is in
good condition. If the light flashes, the sensor is
good.
REAR DIFF SOLENOID SERVICE
DIFFERENTIAL SOLENOID OVERVIEW
The differential solenoid
q
is located on the rear portion
of the transmission case. The solenoid actuates a shift
fork with an engagement dog, which locks and unlocks
the rear differential.
DIFFERENTIAL SOLENOID CIRCUIT
OPERATION
The Rear Diff Solenoid Relay is attached to the rear
portion of the main frame and can be accessed by tilting
the rear cargo box.
When the switch is pushed to activate “TURF”, a ground
signal is provided to the ECU from the AWD switch.
Depending on engine speed and gear position criteria,
the ECU energizes the Rear Diff Solenoid Relay allowing
it to enable the differential solenoid.
If the rear diff fails to switch from operational modes:
• Check the solenoid and relay connectors. Look for
loose wires or bad connections.
• Check for power from the relay connector, to ensure
the solenoid has power to be activated.
• Check the AWD switch wires for loose connections.
• Remove solenoid from rear differential and ensure the
solenoid plunger is actuating.
CAUTION
Do not power the solenoid with 12 Volts for more than 1
second, or damage may occur to solenoid.
CHASSIS / BODY ELECTRICAL