Polaris MATRIX 650 INDY VR1 129, Owner'S Manual

Page: 132 / 243

WARNING
Use of traction products such as studs increases the possibility of track
damage and/or failure. Driving at high speeds for extended periods of time in
marginal lubrication could severely damage track rods, break track edges, and
cause other track damage. Examples of marginal lubrication would include
frozen bodies of water without snow cover, icy trails, and no-snow conditions.
HOOD AND SIDE PANEL FASTENERS
CAUTION
The hood and side panels of the snowmobile protect the operator from moving
parts. Never operate a snowmobile with the hood or side panels open or
removed. Always ensure that the hood and side panels are securely in place
before starting the engine.
RECOIL ROPE
Inspect the recoil rope and handle for excessive wear, and make sure the knot
securing the rope inside the handle is secure. If excessive wear is found, your
POLARIS dealer can provide a replacement.
START THE ENGINE AND CHECK
Before starting the engine, always refer to all safety warnings pertaining to
snowmobile operation. Never engage the starter when the engine is running.
Never start the engine without checking all vehicle components to be sure of
proper operation. See page 127.
ENGINE STOP SWITCH
Check the auxiliary shut-off switch for proper operation. Push the switch down to
stop the engine. Pull it up to allow restarting.
IGNITION SWITCH
Make sure the engine stops when the ignition switch is turned to OFF.
TETHER SWITCH (IF EQUIPPED)
If your snowmobile has a tether switch, remove the tether from the switch to
make sure the engine stops immediately.
LIGHTING
Check the headlight (high and low beam), taillight, and brake light. Replace
burned out lamps before operating.
130
PRE-RIDE INSPECTIONS