Page 17
|
Polaris
®
AutoClear
®
SC (PAGSC20K) Salt Chlorinator - Installation and Operation
Manual
ENGLISH
BOOST
Section 5. Operating Instructions
- Exit the user menu.
- Deactivate Boost
mode or Low mode.
- From the home
screen: increase or
decrease in chlorine
production.
- In the user menu:
value changes when
a choice is proposed
(flashing characters).
- Access to user
menu and navigation
in the settings (with
successive presses)
- Activate/deactivate
the chlorine
production by a short
press.
- Switch off the device
with a long press
- Switch on the device
with a short press
- Press buttons
together to activate
Boost
mode manually
5.1 Setting the Clock
The saltwater chlorine generator is fitted with an internal
memory and is fitted with battery back up that will
maintain memory for several weeks in the event of a
power failure. The time is displayed in a 24 hour format.
Switch on the device and wait until screen start-up
sequence is finished.
to correctly treat the water. The saltwater chlorine
generator has default settings of Timers 1 and 2.
However they can be customized.
The saltwater chlorine generator can store 2 seasonal
operating modes called by default "SMR" and "WIN".
The following settings can be customized for each mode:
- the device operating times, the "timers": T1 (Timer 1)
and T2 (Timer 2)
- the required chlorine production rate: 10 %, 20 %, 30
%,... up to 100 %.
STANDBY =
Device operating status
T =
“Timer” mode (always active)
SMR =
“Summer” operating mode
80 % =
chlorine production rate
14:25 =
time in 24 hr format
Mode Selection: “SUMMER” or “WINTER”
• Press
4 times to set the clock.
“SMR”
starts to
flash.
• Use the
and
buttons to choose
“SMR”
or
“WIN”
mode, then press the
button to return to
the home screen.
Programming the Timers According to the Modes
The times of Timers 1 and 2 cannot overlap. In addition,
the time range of Timer 1 necessarily precedes that of
Timer 2.
TS1 / TS2 =
Timer in
“summer” mode No. 1 / Timer in
“summer” mode No. 2
08:00-12:00 =
Operating time range of Timer No. 1
14:00-20:00 =
Operating time range of Timer No. 2
• Press the
button to access the user menu, the
minutes start to flash.
• Use the
and buttons to set the minutes, then
press
to store.
• Use the
and
buttons to set the hours, then
press
to store.
• Press the
button to return to the home screen.
5.2
“Summer” and “Winter” Modes and
Setting
the “Timers”
"Timer" programming is used to define the device
operating times within the filtering system operation
times. The daily operating times must be sufficient
• Press
4 times to set the clock.
“SMR” starts to
flash.
• Select the mode to be customized “SMR” or “WIN”
using the
and
buttons, then press
to
store and move to the timer setting screen.
• Use the
and
buttons to set the Timer 1 stop
minutes, then press
to store.
• Use the
and
buttons to set the Timer 1 stop
hours, then press
to store.
WARNING
do not operate the electrolytic cell without water
result in FIRE OR EXPLOSION.
