Polaris 850 PRO-RMK 155 2.6" QD 2021, Manual

Page: 684 / 747

10.60
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
7. Cycle the power by removing, wait for 10 seconds,
and then re-connect the Chassis Power-Up Harness
to finish the procedure.
SECURITY SYSTEM - AXYS USER NOTES
General Notes:
• Security system activation requires an authorized
Polaris dealer using Digital Wrench to enable security
in the ECU.
• Security is a function of the ECU. If security is set, the
ECU will still limit engine RPM if the hood is removed.
• When security is enabled, engine speed is limited to
approximately 3,000 RPM.
• The instrument cluster or IDD retains the last
programmed security pass code. Disabling and
enabling the security function in the ECU does not
change the code in the instrument cluster. If the pass
code is unknown, perform the Reset Pass Code
Procedure to reset the code back to 000.
• Performing the ECU Replacement Procedure disables
the security function. Perform the Security Enable
procedure after replacing the ECU.
Standard Instrument Cluster Notes:
• First time use after security is enabled requires the
user to perform the gauge / security initialization
procedure to turn on the security function in the
instrument cluster.
• Holding the brake lever closed and pressing the
MODE and SET buttons for 3 seconds will bring up the
security display on the instrument cluster.
• If the brake lever is not held while pressing the MODE
and SET buttons for 3 seconds, the instrument cluster
will start the record / playback data logging feature.
• Pressing the MODE button will accept the selected
digit and move to the next digit. After entering the third
digit, pressing MODE a fourth time will enter the code.
• Pressing the SET button advances each digit up from
0 to 9 then back to 0.
Polaris Interactive Digital Display (IDD) Notes:
• First-time gauge / security initialization is not required
with the IDD.
• If the snowmobile is equipped with a battery, turning
the ignition key to “RUN” will turn on the IDD, but does
not power-up the ECU. The engine must be running or
12V battery power suppled to the ECU PWR test
connector on the Next-Gen Service Power Harness to
access Vehicle Security Settings on the IDD. Security
cannot be accessed if the ECU is not powered.
• If security is enabled in the ECU, the IDD will provide
the security feature as long as the IDD is initialized to
the vehicle.
BATTERY / ELECTRICAL