Polaris 850 PRO-RMK 155 2.6" QD 2021, Manual

Page: 656 / 747

10.32
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
6. Connect and tighten the black (negative) cable last.
IMPORTANT
Verify the battery cables and wiring harness do not
come into contact with the brake disc. Move the wiring
harness/cables behind the chassis tube and away from
the brake disc.
IMPORTANT
Route the BROWN harness ground wires
q
and
BLACK main battery ground cable
w
as shown in the
image. Both are routed up and over the rubber strap. If
the ground wires/cable are routed down the side of the
battery, they may interfere with the rear side panel tab.
Note the routing of the RED (positive) battery cable
e
and that the right fender is pulled away from the
chassis. Item
r
is the constant power fuse connector.
TORQUE
Battery Cable Connector:
36 in-lbs (4 Nm)
7. Verify that cables are properly routed.
NOTICE
Ensure that the battery wires are routed in such a way
that they cannot come into contact with the brake disc.
8. Secure the right fender using the plastic rivet.
9. Reinstall the console using the two plastic rivets.
10. Reinstall the side panel.
BATTERY IDENTIFICATION
IMPORTANT
It is important to identify what type of battery is installed
in the vehicle. Different types of batteries require
different service procedures. Proper servicing and
upkeep of the battery is very important for maintaining
long battery life.
The types of batteries are
• Dry Shipped Absorbed Glass Mat (AGM)
• AGM Low Maintenance
To identify which type of battery the vehicle has, refer to
the examples below and follow the correct service
procedures that follow in the manual.
DRY SHIPPED AGM BATTERY
• Battery NOT activated when packaged
• Removable cap plugs / strip on top of battery
• Distilled water added as required (Lead Acid only)
• Vent tube on side of battery (Lead Acid only)
BATTERY / ELECTRICAL