Polaris 850 PRO-RMK 155 2.6" QD 2021, Manual

Page: 195 / 747

2
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
2.59
LIGHTS
AXYS LED LIGHTS
The headlight
q
assembly features LED elements and
are not serviceable. If an LED fails to illuminate in either
the headlight, the entire assembly must be replaced.
NOTICE
The headlight low-beam emitters are always powered
when the engine is running. Selecting high-beam adds
the high-beam emitters to the array.
The taillight
w
assembly features LED elements and are
not serviceable. If an LED fails to illuminate in either the
taillight, the entire assembly must be replaced.
NOTICE
Image for reference only.
HEADLIGHT ADJUSTMENT
The headlight can be adjusted for vertical aim using the
following procedure.
1. In a well-ventilated area, position the snowmobile on
a level surface with the headlight approximately 25
feet (7.6 m) from a wall.
2. Place the rider or the approximate weight of the rider
on the seat or tunnel floorboards.
3. Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the
same height.
4. Start the engine. Move the headlight switch to high
beam.
5. Observe the headlight aim on the wall. The most
intense part of the headlight beam should be two
inches (5 cm) below the mark on the wall.
6. If adjustment is necessary, access the headlight
adjuster knob through the left side panel. Turn the
adjuster knob clockwise to lower the beam. Turn the
adjuster counterclockwise to raise the beam.
MAINTENANCE