Polaris 850 PRO-RMK 155 2.6" QD 2021, Manual

Page: 140 / 747

2.4
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
MAINTENANCE OVERVIEW
EMISSION CONTROL INFORMATION
Any qualified repair shop or person may maintain,
replace, or repair the emission control devices or
systems on your snowmobile.
EMISSION CONTROL LABEL
Your snowmobile is equipped at the time of sale with an
emission control information (ECI) label and a factory-
installed emissions information hangtag. These items are
required by U.S. Environmental Protection Agency
regulations. The ECI label is permanently affixed to
either the right side of the tunnel or the engine recoil
cover. The ECI label should not be removed, even after
you purchase the snowmobile. You may remove the
factory-installed emissions information hangtag, which is
intended solely for your use in making a purchasing
decision.
EMISSION CONTROL MAINTENANCE
REQUIREMENTS
Your snowmobile is certified to operate on gasoline with
a minimum octane level of 87 (R+M)/2. If the check
engine light comes on, you must take your snowmobile
to a qualified dealer for diagnostic service. Specifications
and adjustments for engine tune-ups are located in the
Service Manual, which is available to your qualified
service technician. Reverse (if equipped) must not be
engaged during engine tune-ups.
NON-IONIZING RADIATION
This vehicle emits some electromagnetic energy. People
with active or non-active implantable medical devices
(such as heart monitoring or controlling devices) should
review the limitations of their device and the applicable
electromagnetic standards and directives that apply to
this vehicle.
NOTICE
The speedometer may give wrong values at the
existence of electromagnetic radiation >= 10 V/m.
AXYS SPARE BELT HOLDER / TOOLS
A driven clutch L-wrench and a spare belt container / tool
kit are provided with the snowmobile. The spare belt
holder has provisions for two spark plugs and is secured
to the front bumper with the spark plug / Torx screw tool.
Open the left side panel to access the tools.
NOTICE
The spare belt and spark plugs are not included with
the vehicle from the factory.
The L-wrench is used to open and close the driven clutch
when working with the drive belt. The L-wrench, when
properly engaged in the bracket, secures the fender to
the console. To retrieve the L-wrench, rotate it
counterclockwise and slide it upward from the bracket.
When it’s not in use, return the L-wrench to the bracket
and rotate it clockwise.
The tool kit is stored in the spare belt holder attached to
the left tube of the front bumper. Use the following
procedure to remove the spare belt container from the
snowmobile.
1. Open the left compartment door panel.
MAINTENANCE