73
THE PERFECT FIT
Cyclone Brake Master Cylinder Alignment
1. Loosen the two mounting screws.
CAUTION!
Take care to avoid damaging hand
warmer/brake switch wires when moving
components.
2. Move the master cylinder to the
desired position.
3. Tighten the screws to specification.
Torque the front screw (1) first, then
torque the screw (2) next to the
reservoir. Do not over-torque.
Torque:
60-80 in-lbs (6.7-9 Nm)
Throttle Block Alignment
1. Slightly loosen the set screw on the
bottom of the housing.
2. Move the control block to the
desired position.
NOTICE:
Take care to avoid damaging hand
warmer wires when moving
components.
3. Tighten the screw to specification.
Do not over-torque.
Torque:
27 in-lbs (3 Nm)
4. With the engine off, test throttle lever movement after tightening the
screw. See page 93.
PERC Button Alignment
1. Loosen the mounting screw.
2. Move the PERC button to the
desired position.
3. Tighten the screw to specification.
Do not over-torque.
Torque:
35 in-lbs (4 Nm)
Mounting Screws
2
1
Throttle Block
Set Screw
PERC Button
Screw