Polaris 2011 RANGER RZR, Service Manual, Page: 42 / 418

2.23
MAINTENANCE
2
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
Cooling System Pressure Test
Refer to Chapter 3 for cooling system pressure test procedure.
Cooling System Hoses
1. Inspect all hoses for cracks, deterioration, abrasion or
leaks. Replace if necessary.
2. Check tightness of all hose clamps.
Radiator
1. Check radiator (A) air passages for restrictions or damage.
2. Carefully straighten any bent radiator fins.
3. Remove any obstructions with compressed air or low
pressure water.
Coolant Drain / Radiator Removal
Coolant Drain
1. Remove the hood from the front cab.
2. Slowly remove the pressure cap to relieve any cooling
system pressure.
3. Place a suitable drain pan underneath the radiator fitting on
the front RH side of the vehicle.
4. Drain the coolant from the radiator by removing the lower
coolant hose from the radiator as shown. Properly dispose
of the coolant.
5. Allow coolant to completely drain.
CAUTION
Do not over-tighten hose clamps at radiator,
or radiator fitting may distort, causing a
restriction to coolant flow.
Radiator hose clamp torque is 36 in. lbs. (4 Nm) .
A
Flush radiator fins
in this direction
CAUTION
Washing the vehicle with a high-pressure
washer could damage the radiator fins and
impair the radiators effectiveness. Use of a high-
pressure washer is not recommended.
WARNING
Never drain the coolant when the engine and
radiator are warm or hot. Hot coolant can cause
severe burns. Allow engine and radiator to cool.
Drain Here