Polaris 2008 ranger 700 xp, Service Manual

Page: 38 / 330

2.22
GENERAL INFORMATION
To change gearcase lubricant:
1. Remove gearcase drain plug (B) (11 mm) located on the
bottom of the gearcase and drain oil. (The drain plug is
accessible through the skid plate.) Catch and discard used
oil properly.
2. Clean and reinstall drain plug (B) using a new sealing
washer (A). Toque to 10 ft. lbs. (14 Nm).
3. The fill plug can be accessed through the top hood area by
removing the storage box or by removing the left side panel
in the left wheel well.
4. Remove fill plug (8 mm hex) and check the O-ring.
5. Fill with the recommended fluid amount (5 oz.) or to the
bottom of the fill plug hole threads.
6. Install fill plug and check for leaks.
Middle Gearcase Lubrication (6x6)
The gearcase lubricant level should be checked and changed in
accordance with the maintenance schedule.
• Be sure vehicle is level with parking brake on before
proceeding.
• Check vent hose to be sure it is routed properly and
unobstructed.
• The correct middle gearcase lubricant to use is ATV
Angle Drive Fluid
10 ft. lbs (14 Nm)
A
B
Top View of Hood Area
LH Side Panel
Middle Gearcase Specifications
Specified Lubricant:
ATV Angle Drive Fluid (PN 2871653)
Capacity: 6.75 oz. (200 ml.)
Drain Plug / Fill Plug Torque:
14 ft. lbs. (19.4 Nm)
Fill Plug
Front Gearcase
Plug Threads
Fill with 5 oz.