53
OPERATION
Vehicle Break-in Period
The break-in period for your new Polaris Sportsman 6x6 is defined as
the first ten hours of operation or the time it takes to use the first two
tanks of gasoline. No single action on your part is as important as
following procedures for a proper break-in period. Careful treatment of
a new engine will result in more efficient performance and longer life
for the engine. Perform the following procedures carefully.
1. Fill the fuel tank with either unleaded or leaded fuel that has a
minimum pump octane number of 87= (R+ M)/2.
2. Check the oil reservoir
level indicated on the
dipstick. Add oil if
necessary to bring the
level within the normal
range (1)(see page 118).
3. Drive slowly at first. Select an open area that will allow room to
familiarize yourself with vehicle operation and handling.
4. Vary the throttle positions.
5. Perform regular checks on fluid levels, controls, and areas outlined
on the daily pre-ride inspection checklist. See page 54.
6. Pull only light loads during the break-in period.
7. Break in the oil and the filter. Change both at 20 hours or 200
miles.
CAUTION
Excessive heat build-up during the first three hours of operation
will damage close-fitted engine parts. Do not operate at full
throttle or high speeds for extended periods during the first three
hours of use.
Use of any oils other than those recommended by Polaris may
cause serious engine damage. We recommend the use of
Polaris oil for your vehicle
(see page 118)
.
Lack of proper lubrication will cause serious engine damage.
Always check the oil level when refueling the vehicle.
ADD 8 OZ.
NORMAL
FULL
1
