3)
Remove the two screws from the bottom of the door on the left hand side and install them
on the right hand side of bottom of the door
(Fig 3.)
4)
Remove the right lower door hinge
1
. Take the left lower door hinge
6
from the plastic bag
and install it in designated position on the left hand side. Then install the door shaft
assembly
(Fig 2)
5)
Remove the door axle
5
from the right upper hinge, install and tighten it in the upper left
hinge
(Fig 4.)
6)
Position the door in the designated position and install the two lock screws
2
to connect the
door shaft assembly
3
to the glass door. Tighten them before the door is levelled
(Fig 5).
7)
Remove the handle from the left hand side of the door and install it on the right
Trouble Shooting
Fault Probable
Cause
Action
The wine chiller does not
work
Unit may not be plugged in or
switched on
Plug in and switch on chiller.
Temperature incorrectly set
Check the temperature setting
The door is not completely
shut
Shut door
The door gasket is not sealing
properly
Check door seal fitted correctly
The room temperature is
warmer than normal
Reduce room temperature
The wine chiller is not cold
enough or turns on/off
frequently
The door is opened too
frequently
Reduce number of times door is
opened
The light switch is set to “OFF”
Set light switch to “ON”
The light does not work
Unit may not be plugged in or
switched on
Plug in and switch on chiller.
The display shows “EL” or
“EH”
The air temperature sensor
has failed
Contact Polar agent or qualified
technician
