Rear Panel
The rear panel view of the Switch consists of an AC power connector.
Plug the female connector into the Switch and male connector
into a power outlet. Supports input voltages 100-240VAC, 50/60Hz.
Switch: Turn on the switch after inserting the power cord, “I”
means to turn on, “O” means off.
Grounding: Use specialized ground lead connect.
3) HARDWARE INSTALLATION
This chapter provides unpacking and installation information for
the Switch.
Open a Seal
Open the shipping carton and carefully unpack its contents.
Please consult the packing list located in the User Manual to
make sure all items are present and undamaged. If any item is
missing or damaged, please contact us for replacement.
Switch Installation
For safe switch installation and operation, it is recommended that you:
- Visually inspect the power cord to see that it is secured fully to
the AC power connector.
- Make sure that there is proper heat dissipation and adequate
ventilation around the switch.
- Do not place heavy objects on the switch.
Desktop Installation
When installing the switch on a desktop, the rubber feet included
with the device must be attached on the bottom at each corner
of the device’s base. Allow enough ventilation space between the
device and the objects around it.
poewit.com
1) ABOUT GUIDE
This guide provides instructions to install the NS-8B switch.
NOTE: The model you have purchased may appear slightly
different from the illustrations shown in the document. Refer to
the Product Instruction and Technical Specification sections for
detailed information about your switch, its components, network
connections, and technical specifications.
This guide is divided into four parts:
1. About guide: Terminology/Usage
2. Product introduction: Product overview and panel definitions
3. Hardware installation: Step by step hardware installation process
4. Technical specifications
Terminology / Usage
In this guide, the term “Switch” (first letter capitalized) refers to
this PoE Switch, and “switch” (first letter lower case) refers to
other PoE switches. Some technologies refer to terms “switch”,
“bridge” and “switching hubs” interchangeably, and both are
commonly accepted for Ethernet switches.
Note: Indicates important information that helps a better use of
the device.
Warning: Indicates potential property damage or personal injury.
Copyright and trademark
The pictures and data shown in this guide are for reference only,
subject to change without notice.
2) PRODUCT INTRODUCTION
This Switch is a 10G Full Managed PoE Switch. It provides 8
x10/100/1000Mbps Auto-Negotiation RJ45 PoE ports and 4
x10Gbps SFP ports, which can satisfy the full speed forwarding
of ports. The Switch uses 19” 1U standard chassis rack or can be
used on the desktop.
Front Panel
The front panel consists of LED indicators and network ports.
LED Lamp
Power LED: The Power LED lights up when the Switch is
connected to a power source.
Link/Act indicator: The light indicates the network connection
through the corresponding port. Flicker indicates that the switch
is sending or receiving data.
PoE indicator: Blinking indicates that the PD device is connected
to the corresponding port, and Off indicates that the port is not
powered or no PD device is found.
NS-8B
- Switch 1 pcs
- AC power cord 1 pcs
- Rubber feet 4 pcs
- Screws 6 pcs
- Mounting brackets 2 pcs
- User’s manual 1 pcs
- Serial port lines 1 pcs
INP UT: 100-240VA C
USE ON
LY
WITH 250V FUSE