Selects 1 of 15 DTMF codes. The DTMF codes are programmed with software and are up to 5 digits each.
(19) SCAN Resume Mode (SC-REV) - MENU No.18
Thanks to this function, P52UV can SCAN in frequency or channel mode. You can choose amongst three options:
•
TO: Time-operated SCAN
Whenever a signal is detected, the radio will suspend the SCAN for 5 seconds, and then will continue to SCAN even if the
signal is still present.
•
CO: Carrier-operated SCAN
Whenever a signal is detected, the radio will stop scanning. It will resume to SCAN once the signal will disappear.
•
SE: Search SCAN
The radio will stop scanning once a signal is detected.
(20) PTT-ID (PTT-ID) - MENU No.19
With this function you can decide when sending the ANI-ID code in tx mode.
You can choose amongst 4 possibilities.
•
OFF:
press PTT to turn it off
•
BOT:
the code is sent when you press the PTT
•
EOT:
the code is sent when the PTT is released
•
BOTH:
the code is sent when you press and release the PTT
Note: select ‘OFF’ when using in case of affecting the radio.
(21) PTT ID delay (PTT-LT) - MENU No.20
In this MENU you can set the delay time (0-30ms) sending the PTT-ID.
Note: select ‘0’ in normal using.
(22) Channel A Display Mode (MDF-A) - MENU No.21
This function is used to set the display mode of channel A.
Display modes:
•
FREQ.:
Fre channel No.
•
CH:
Channel number
•
NAME:
Channel name
Note: Channel name mode must be set by the programming software. Up to three numbers or characters can be edited.
