a.
Turn off the radio. Press and hold the
[MENU]
key to turn on the radio and return to the frequency
（
VFO) mode. The
channel number on the right will disappear.
b.
Use the numeric keypad to enter the repeater's output (your receiving) frequency.
c.
Press the
[MENU]
key to enter the menu.
d.
Enter
[2][6]
on the numeric keypad to get to frequency offset.
e.
Press
[MENU]
key to select.
f.
Use the numerical keypad to enter the specified frequency offset. See the section called “26 OFFSET - Frequency shift
amount” for details.
g.
Press
[MENU]
to confirm and save.
h.
Enter
[2][5]
on the numeric keypad to get to offset direction.
i.
Use the
▲
/
▼
keys to (positive) or - (negative) offset.
j.
Press
[MENU]
to confirm and save.
k.
Optional:
a). Save to memory, see the section called “Manual programming” for details.
b). Set up CTCSS; see the section called “CTCSS” for details.
l.
Press
[EXIT]
to exit the menu. If everything went well, you should be able to make a test call through the repeater.
NOTE:
If you're experiencing problems making a connection to the repeater, check your settings and/or go through the procedure
again.
Certain Amateur Radio repeaters (especially in Europe) use a 1750Hz tone burst to open up the repeater. To see how this is
done with the Pofung P52UV, see the section called “1750Hz Tone-burst”.
If you're still unable to make a connection, contact the person in charge of the radio system with your employer or your local
amateur radio club, as the case may be.
If you for some reason want to listen to the repeater's input frequency instead, press
[*SCAN]
key momentarily and you'll
reverse your transmit and receive frequencies.
This is indicated in the LCD on the radio with an R in the top row, next to the
+
and
-
for the offset direction.
