EN
User manual
VERY IMPORTANT WARNINGS
•
If you want to receive photo only by e-mail, disable MMS and FTP, and do not enter
phone numbers in the “Send To” menu.
•
If you want to use the MMS function, make sure that you have the active MMS
function on the SIM card and that you have previously tested the function in a phone
(meaning, you can send and receive an MMS with this card).
•
Test your SIM card in a phone and make sure you have Internet (mobile data), SMS
(for communicating with the Trail Camera smartphone application), credit and MMS
enabled.
•
The camera will automatically enter the 4G and MMS settings (only if you use the
function) when the SIM card is inserted. If the message “SIM Automatch failed”
appears on the screen, enter the settings manually, switch the “SIM Auto Match”
mode to “Manual”, then enter the 4G and/or MMS settings (if you use the function);
•
For emails, enter your email address in “Send to” - “Email” (up to 4 email addresses
can be set).
•
For MMS, enter your mobile phone numbers in “Send to” - “Phone” (up to 4 phone
numbers can be set) (only if you use the function)
Note: For detailed menu settings, refer to the instructions in the menu options chapter
•
After you have finished all the settings, press the “Menu” button to return to the home
screen, then move the ON/SETUP/OFF switch to the ON position; the LED will turn
off and the camera enters the motion detection mode.
* In motion detection mode, the camera will automatically take photos and videos and
send photos to your mobile phone or email every time it detecs motion.
TESTING - EMAIL SENDING
After you have passed the previous steps (SIM card verification, signal, 4G settings
auto-configuration) just do the following:
1. Disable MMS and FTP from the camera menu; The SMTP function must be set to
Default (the default e-mail server of the camera).
2. Enter your email address that you want to receive the picture on in the “Send To”
3. Do not make other settings changes in the camera.
4. Press the Menu button until you exit the menu, and you will have the image taken from
the camera on the screen.
5. Press the OK button to make and send a test picture.
6. The status messages for the picture will appear on the screen: “Send SMTP”/“Send
Failed” and if applicable an error code.
7. If the message is “Send successfully” check your email address, including the SPAM
folder.
8. If the message is error, check again that the settings made are correct as indicated
above.
5
