EN
User manual
Wireless mode
LTE Cat.4 modules
Operating temperature
-30°C to 60°C
Waterproof
IP66
Dimensions
148 x 117 x 78 mm
Weight
448g
APP
IOS & Android
TROUBLESHOOTING
Photos do not capture subject of interest
1. Check the “Sensor Level” (PIR sensitivity) parameter setting. For warm environmental
conditions, set the Sensor Level to “High” and for cold weather use, set the sensor
for “Low”.
2. Try to set your camera up in an area where no heat resources are in the camera’s
field of view.
3. In some cases, set the camera near water will make the camera take images with no
subject in them. Try to aim the camera over ground.
4.
Try to set camera on stable and immovable objects, i.e.: large trees.
5. At night, motion detector may detect beyond range of the IR illumination. Reduce
distance setting by adjusting sensor sensitivity.
6. Rising sun or sunset can trigger sensor. Camera must be reoriented.
7.
If person/animal moves quickly, it may move out of the camera’s field of view before
photo is taken. Move camera further back or redirect camera.
Camera stops taking images or won’t take images
1. Please make sure that the SD card is not full. If the card is full, camera will stop
taking images. Or user can turn on Cycle Recording to avoid such problem.
2. Check batteries to make sure that alkaline, or NiMH AA batteries left power is enough
for camera to work.
3.
Make sure that the camera power switch is in the “On” position and not in the “Off”
or “Setup” modes.
4. When GPRS function is on, there will be around 1 minute interval for camera to send
out photo before camera shooting the next photo. Turn off the GPRS, camera can
shoot photos continuously.
5. Please format the SD card with camera before using or when camera stops taking
images
Night vision flash range doesn’t meet expectation
1. 4pcs AA batteries is not able to support camera night vision ability; please install 8
pcs AA batteries;
2. Please check to make sure that batteries are fully charged or left power is enough;
3.
“Max Range” offers better IR flash range. Given IR flash range values are based
on Max Range setting; so please adjust Night Mode to Max Range for better night
20
