Electrical connections
Depending on version:
•
Flat-pin connectors 1 x 6,3 mm or
2 x 2,8 mm to DIN 46 244
•
Screw terminals for conductor
cross-section from 0,5 to 2,5 mm²
Mounting
Panel mounting with two fixing clamps
at top/bottom or left/right
Close mounting possible
Mounting position:
not critical
Weight:
0,27 kg (9.52 oz)
Accessories supplied with unit
Operating instructions
2 fixing clamps
ACCESSORY EQUIPMENT
BlueControl (Engineering Tool)
PC-based program for configuring,
setting parameters, and operating
(commissioning) the KS 50-1 controller.
Moreover, all the settings are saved, and
can be printed on demand.
Depending on version, a powerful data
acquisition module is available, complete
with trend graphics.
Visibility mask
The BlueControl software can be used
to blind out parameters in the
instrument. Thus, only alowed
parameters can be changed on side.
Safety relevant parameters are invisible!
Simulation
The built-in simulation serves to test the
controller settings, but can also be used
for general training and observing the
interaction between controller and
control loop.
Software requirements
Windows 95/98/NT/2000.
Configurations that can only be
implemented via the BlueControl
software (not via the front-panel keys):
•
Customer-specific linearizations
•
Enable „forcing“ for inputs/outputs.
Forcing allows to write the analog and
digital inputs and outputs via Modbus
interface.
•
Adjustment of limits for operating
hours and switching cycles
•
Switch-over to 60 Hz mains
frequency
•
Master/slave configuration
•
Disable operator actions and
operating levels, plus password
definition
•
Prevent automatic optimization of
cycle times T1, T2
Hardware requirements:
A PC adapter (see „Accessories“) is
required for connecting the controller.
Updates and demo software can be
downloaded from:
www.pma-online.de
KS 50-1
7
Functionality
Mini
Basic
Expert
parameter and configuration setting
yes
yes
yes
controller and control loop simulation
yes
yes
yes
download: writes an engineering to the controller
yes
yes
yes
online mode/ visualisation
SIM only
yes
yes
creation of user defined linearizations
SIM only
yes
yes
configuration of extended operating level
SIM only
yes
yes
upload: reads an engineering from the controller
SIM only
yes
yes
basic diagnosis function
SIM only
yes
yes
file, save engineering data
no
yes
yes
printer function
no
yes
yes
online documentation, help system
no
yes
yes
measurement correction (calibration procedure)
no
yes
yes
program editor
SIM only SIM only
yes
data acquisition and trend function
SIM only SIM only
yes
network and multiuser licence
no
no
yes
personal assistant function
no
no
yes
extended simulation
no
no
yes
extended diagnostic and service functions
no
no
yes
BlueControl, versions and functionality:
Two parameters are blinded out:
