5
Method III
– by using a computer
1.
Log in to your NVR using the IP address of the NVR and open the “Setup” > “System” > “Status”
page. The UDID will be listed there.
2. Write down the UDID.
Connect to your NVR from any computer using EasyLink and UDID
2
1. Visit our website to download the EasyLink setup program or insert the installation CD into your
CD-ROM drive. Launch the setup program to install the EasyLink program. If you used the USB
drive method to obtain the UDID, connect it to your computer.
2. Launch the EasyLink program from the shortcut from your desktop. If you used the USB drive
method to obtain the UDID, launch the EasyLink.exe file on your USB drive. If you are prompted
to allow the program through the Windows Firewall, please click on the “Allow access” button to
allow it.
3. Enter the 20-digit UDID into the UDID field. If you used the USB drive method described earlier,
the UDID will be loaded automatically. Enter the HTTP port number if needed. The default port
number is 80.
4.
Click on the “Create Tunnel” button.
5.
Click on the “Connect” button. The NVR’s login window will open in your default web browser.
6. Enter the
NVR’s “Username” and “Password” and change the “Language” if necessary, then
click on the “Login” button to log in to the NVR.
Attention
The connection dialog of the EasyLink program has to be kept open when
using this method to connect to your NVR. If you accidently close the
EasyLink
program, just launch it again and click on the “Create Tunnel” button
to continue using your NVR.
If the NVR system times out due to inactivity, you need to close and re-launch
the EasyLink
program. Then click on the “Create Tunnel” button to continue
using your NVR.
When you are done using the NVR, click on the “LogOut” button on the NVR
homepage, then click on the “Close” and “Exit” button in the EasyLink
program.
2
This feature is available with “P” series products.
