17
Cleaning the Scanner
When you use this scanner for the very first time after installation, you are
suggested to clean the scanner before use.
If unusual dots or lines are found in your scanned image, it is very likely that dust
particles or other foreign objects have been brought inside the scanner. You may clean
the scanner to rectify the problem.
The following describes how to clean the scanner:
1. Insert the special cleaning paper into the page feed slot of the scanner.
Attention
Do use the cleaning paper included in our package box.
Remember to replace the cleaning paper in a safe and
clean place when you finish using it.
Do not use anything other than our cleaning paper to clean
your scanner. Using other sheet will influence the scan
quality or even lead to scanner malfunction.
2. From the Windows
START
menu, point to
All Programs
>
Your Scanner
Model Name
, and then click
Clean Wizard
. (For Windows 8.1 users: Point your
mouse cursor to the upper or lower right corner of your screen to open the
Charm
bar. Click on the
Start
charm, then click on the downwards arrow button
in the lower left corner of the screen. The
Apps
screen will be shown. Move
your cursor to the right edge of the screen to scroll right until you find
Your
scanner model name
, and then click on
Clean Wizard
.)
3. Click
Clean Now
from the window that pops up, and click
Clean
from the
window that pops up.
4. The scanner pulls the cleaning paper through the scanner, which completes
this scanner cleaning.
Power Save
To save power consumption, when the scanning process is finished, the scanner
light source will turn itself off and the scanner will enter a lower-power mode without
delay time.
