Operating Manual MTD-ID
Page 12
Configuration
MTD-ID is configured by its base unit (SPT, TCU or TCUE resp.). Please refer to chapter
“Configuration” of the base unit’
s manual for details. Y
ou’ll need the
UD SC Config.exe tool;
alternative you can use the web interface.
MTD-
ID is configured on the “MTD
-
ID” page:
Brightness
Backlight
Brightness of the display: 7 steps, 7 = maximum brightness.
Format
Mode
Operating modes of the display
–
dependent on “Source” selectio
n. Please
refer to chapter “
Display
” of the base unit’s manual for details
.
Color
Display color:
Auto
If “Source”
=
“SPT”, “LTC(MTD)”
or “MTD”:
The display decodes the color out of the MTD data.
Red/Yellow/Green
Delimiter
Separating sign between pairs of digits:
Auto
If “Source”
=
“SPT”, “LTC(MTD)” or “MTD”:
The display decodes the separating sign out of the MTD
data.
Off
No separating sign.
Decimal Points
Colon
Summary of Contents for MTD-ID
Page 1: ...Operating Manual Version 1 2 September 26 2019 MTD ID Additional display for TCUE TCU SPT...
Page 2: ......
Page 10: ......
