Charge RP Batteries
Take care to insert the Radio Pack batteries with the contacts facing down into the Radio Pack and
oriented such that the contacts on the battery will line-up with the contacts inside the Radio Pack battery
compartment. See
"Install Radio Pack Batteries" on page 33
for more on this procedure.
The PBT-LIP-01 battery can be charged either inside the Radio Pack with the provided RP Wall
Charger, with the provided USB Cable, with the Pliant 5-Bay Battery Charger (PBT-5BAY-01), or with
the Pliant 6+6 Drop-In Radio Pack and Battery Charger (PBT-RPC-66).
Using the RP Wall Charger
To charge the Radio Pack (RP), connect the plug-in battery charger (included with the RP) to a standard
wall outlet and to the Micro-USB connector on the RP. The connector is located under the rubberized
access cover on the side of the RP. The battery requires approximately 3 hours to charge from empty.
Using the USB Cable
The Radio Pack (RP) may also be charged by connecting the USB-A-to-Micro-B pairing cable to the
USB port of a PC and to the Micro-USB connector on the RP. The connector is located under the
rubberized access cover on the side of the RP. The battery requires approximately 3 hours to charge
from empty.
Using the 5-Bay Battery Charger
Pliant offers a 5-bay battery charger (PBT-5BAY-01) for charging up to five (5) Pliant lithium-polymer
batteries. Batteries require approximately 3 hours to charge from empty.
Figure 10
5-Bay Battery Charger
Setup and Installation - 31
