IMPORTANT NOTES: Read First
For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
ACCESSIBLE DRIVER PANEL ASSEMBLY
INSTALLATION INSTRUCTIONS
Rev G
8/2/2012
1628
Page 1 of 4
(A) Use liquid thread lock (such as Loctite
®
) with all threaded hardware. Important: Liquid thread lock (prior to
curing) helps to eliminate the common problem of "thread seizure" in stainless steel hardware by serving as a
lubricant during assembly.
(B) Refer to Installation Manual for 09 Collars and 11 Socket Clamps installation instructions.
(C) All gaps created (e.g. between panels, between panel and deck, between panel and roof, etc.) must be less
than 3-1/2" [89mm] or greater than 9" [229mm].
(D) Clearance between the finish grade and bottom of play equipment (e.g. activity panel, drive wheel, etc.)
for ADA compliant activities must be greater than 24" [610mm].
(E) An appropriate energy absorbing safety surface is required under and around all playground equipment.
Loose fill protective surfacing is shown only as an example for the purpose of this assembly instruction. Other
surfacing material may vary in thickness and/or compression depths. See free publication - The Handbook for
Public Playground Safety, Publication #325 at www.cpsc.gov for the surfacing appropriate for the fall height of the
equipment or consult your surfacing supply representative.
but does not effect assembly.
R3.5 configuration will vary slightly,
NOTE: R5 ADA Driver Panel shown.
FIGURE 1
ADA Driver Panel
09 Collars and 11 Clamps
See Installation Manual Sections
Figure 1.1
