Platinum PRO Treadmill 3.0, User Manual

Page: 32 / 56

English
26
To stop the equipment:
- Set the mains power switch to the off position.
- Remove the mains plug from the wall socket.
- Remove the mains plug from the equipment.
Safety key
(FIG. E-1)
The equipment is equipped with a safety key that
must be properly inserted into the console to start
the equipment. If you remove the safety key from
the console, the equipment will stop immediately.
- Insert the safety key into the slot in the console.
- Make sure that the clip of the safety key is
properly attached to your clothing.
Make sure that the clip is not removed from your
clothing before the safety key is removed from the
console.
Circuit breaker
(FIG. E-2)
The equipment is equipped with a circuit breaker
that interrupts the circuit when the electricity load is
above the maximum capacity. When this occurs, the
circuit breaker must be pressed.
WARNING
• Before pressing the circuit breaker, remove
the mains plug from the equipment.
If the equipment shuts down, proceed as follows
to restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the equipment.
- Insert the mains plug into the equipment.
Console
(FIG. F)
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is
covered with drops of sweat.
• Do not lean on the console.
NOTE
• The console switches to standby mode when
the equipment is not used for 4 minutes.
Jog wheel and Buttons
Back, Stop button:
- Move back to previous window
- Stop the active training