Planmeca Proline EC ceph, Technical Manual

Page: 39 / 210

Chapter B - KEYBOARD FUNCTIONS & MODES
Planmeca Proline EC X-ray unit B-15
SERVICE MODE KEYBOARD FUNCTIONS
Technical Manual
Pressing down the exposure key after the tube type programming starts the generator with 70
kV and 2 mA (the system adjusts for these values automatically). The system regulates the fil-
ament voltage to get the 2 mA tube current accurate, changes to 3 mA and so on till all tube
current values up to 12 mA have been adjusted. After the learning procedure the generator
stops and the tube type display stops blinking to indicate that the system is now ready for nor-
mal operation. If the exposure switch is released before the procedure is complete (about 2
minutes), it will be continued from that point on when the switch is operated again. If the
power was switched off the procedure starts from beginning. When the tube filament defini-
tion is done the exposure time display will indicate “t.5” for Toshiba tube.
3.10 Model selection
NOTE Always check the model type when the Keyboard processor board is replaced.
The equipment software has been equipped with the software for the PM 2002 CC, Planmeca
Proline CC, PM 2002 EC and Planmeca Proline EC X-ray units. In the service mode it is
determined what the equipment model is.
EC/ EC Proline
Press the CTL-key and press and hold the mA- -key for 10 seconds to change the model of
the X-ray unit.The X-ray unit will restart and the software version number is shown on the
main display, 3.00 or larger for the Planmeca Proline EC and 2.xx for the PM 2002 EC X-ray
unit.
EC Proline/ CC Proline
Press the CTL-key and press and hold the kV+ -key for 10 seconds to change the model of
the X-ray unit. The new model of the unit is indicated for a few seconds in the main display,
EC for the Planmeca Proline EC and CC for the Planmeca Proline CC X-ray unit.
mA
hold for
10 seconds
CTL
kV CTL
hold for
10 seconds