Planmeca Proline CC, Technical Manual

Page: 25 / 207

Chapter B - KEYBOARD FUNCTIONS & MODES
Planmeca Proline CC panoramic x-ray B-11
Technical Manual
3.3 Service mode settings
NOTE Make sure that the unit is in the service mode before performing the functions described
in this section.
Press the control (CTL) key to enter the special function mode. The CTL-key’s indicator light
comes on. In the special function mode some of the keys have special functions, others do not
operate in this mode. When the CTL-key or a special function key is pressed, the indicator light
goes off and the keyboard is in the normal mode. In the following the special functions are
explained.
Table 4: Service mode keyboard function short-form
SERVICE MODE
FUNCTION
KEY SEQUENCE IN SERVICE MODE
FOR DETAILS,
REFER TO
DISPLAY EXPOSURE
COUNTER “Exposure counter
display” on page B-
13
DISPLAY ERROR HIS-
TORY “Error history dis-
play” on page B-13
UP/DOWN MOTOR
SLOW SPEED
ADJUSTMENT “Up/down motor
slow speed adjust-
ment” on page B-14
PRIMARY SLOT CALI-
BRATION “Primary slot calibra-
tion” on page D-7
Dimax3:
“Radiation beam
adjustment” on page
E-14
EXPOSURE SWITCH
SELECTION “Exposure switch
selection” on page
B-14
PATIENT POSITION-
ING MECHANISM
ADJUSTMENT “Patient positioning
mechanism adjust-
ment” on page D-14
Dimax3:
“Patient positioning
mechanism adjust-
ment” on page E-31
PANORAMIC/CEPHA-
LOSTATIC SETUP “Panoramic/cepha-
lostatic setup” on
page B-15
OR OR
CTL
CTL READY
PRET
OR
hold for
4 seconds
CTL
CTL
°
mm
READY
PRET
°
mm
hold for
4 seconds
CTL
CTL
hold for
4 seconds
CTL READY
PRET
hold for
4 seconds
CTL
°
mm
CTL