WARNING
The extraction unit provided by Planmeca is intended solely for the
extraction of DRY milling dust. Do not extract any coolant lubricant with
the extractor provided by Planmeca. This may lead to damage or even
destruction of the extraction unit.
Use disposable towels to remove any residual coolant lubricant from the unit.
Do not use compressed air to remove milling dust from the unit. This may
cause fine dust to get into the mechanics of the unit and lead to the unit
being damaged or destroyed
Cleanliness and regular cleaning will increase the service life of the unit.
16.8.5 Starting milling process
Steps
1. Insert the workpiece.
For instructions, see section "Inserting workpiece/blank" on page 68.
2. If you are wet milling, check the coolant lubricant fill level.
3. Close the protective door.
4. Open the
Jobs menu item.
5. Press Load milling file to open the
Select job menu.
6. Select the milling file.
7. Confirm your selection.
Wait until the milling file has been validated. If problems arise during
validation, follow the instructions on the screen.
8.
When the file has been successfully validated and all necessary tools
are available, press Start processing.
16 Operating milling unit
User's manual
Planmeca PlanMill 60 S 77
