4 For your safety
The following section discusses points relevant to maintaining the highest
possible level of safety to personnel as well as to operating the unit safely
and error free.
4.1 Notes, cautions and warnings
The following warning fields label hazards according to their risk level
(hazard level) and contain important safety-relevant information on handling
the milling unit. The information field contains (important) instructions and
additional information. Also always observe the generally valid accident
prevention regulations and the internal health and safety regulations.
WARNING
Danger with moderate degree of risk!
Provides information on hazards with a moderate degree of risk, which could
result in death or serious injury unless avoided.
CAUTION
Danger with low degree of risk!
Provides information on hazards with a low degree of risk, which could result
in minor or moderate injury unless avoided.
NOTE
Provides important information.
4.2 Residual risks and fundamental dangers
The general residual risks and fundamental dangers which arise during
intended use of the milling unit are listed in this section.
WARNING
Risk of injury due to general residual risks.
Despite compliance with the protective measures, the following residual risks
exist when working on the milling unit:
•
Risk of injury due to cutting, impacts and crushing!
•
Hearing damage due to noise pollution!
•
Health damage due to dust / fine dust pollution!
•
Operation by two persons (simultaneously) is strictly prohibited for safety
reasons!
4 For your safety
User's manual
Planmeca PlanMill 50 S 9
