Planmeca Ethernet interface 3
INSTALLATION OF THE PLANMECA ETHERNET INTERFACE BOX TO THE DIXI3 DIGITAL INTRA X-RAY
Installation manual
2.2
Installing Planmeca Ethernet Interface
To install the Planmeca Ethernet Interface first attach the Ethernet interface box to the power
supply and plug the power supply to the mains. Check that the
OK
indicator light
on the Plan-
meca Ethernet Interface box comes on (see picture below).
Attach the RJ45 Cat. 5 UTP cable from 10/100 Base-T directly to the hub or the cross-con-
nected Cat. 5 UTP cable to the computer. The
Link
light comes on on the Planmeca Ethernet
Interface.
Attach the 15m interconnection cable from Dixi3 either to Port 1 or Port 2 (or to both of them
in case you use two Dixi2 systems). Check also that the
PWR
(power)
light comes on.
OK indicator light
Power supply
cable
OK
SET
STATUS
TX/RX
LINK
PLANMECA ETHERNET INTERFACE
10/100 Base-T
PLANET
PORT 2
PWR
PORT 1
13,2VDC IN
max. 1A
et_bo
x2.eps
OK
SET
STATUS
TX/RX
LINK
PLANMECA ETHERNET INTERFACE
10/100 Base-T
PLANET
PORT 2
PWR
PORT 1
13,2VDC IN
max. 1A
et_bo
x3.eps
Link
PWR
3-metre RJ45 cable
Summary of Contents for Ethernet Interface
Page 26: ......
