Planet WSG-500, User Manual, Page: 25 / 162

User’s Manual
WSG-500 Wireless Hotspot Gateway
ENGLISH
21
3.5.3 Configure Zone Network
Configure Zone network; go to: System >> Zone Configuration . Click the button Configure of
Private zone for further configuration. The parameter descriptions of Basic Settings for Private Zone
and Public Zone are the same. The wireless settings under each zone will be covered in the next
section.
¾
Network Interface:
o
Operation Mode: Contains NAT mode and Router mode. When NAT mode is chosen,
the service zone runs in NAT mode. When Router mode is chosen, this zone runs in
Router mode.
o
IP Address: The IP Address of this zone.
o
Subnet Mask: The subnet Mask of this zone.
¾
DHCP Server: Related information needed on setting up the DHCP Server is listed here.
Please note that when “ Enable DHCP Relay” is enabled, the IP address of clients will be
assigned by an external DHCP server. The system will only relay DHCP information from the
external DHCP server to downstream clients of this zone.
o
Start IP Address / End IP Address: A range of IP addresses that the built-in DHCP
server will assign to clients.
Note: please change the Management IP Address List accordingly (at System >>
General >> Management IP Address List ) to permit the administrator to access the
WSG-500 admin page after the default IP address of the network interface is changed.
o
Preferred DNS Server: The primary DNS server that is used by this Zone.
o
Alternate DNS Server: The substitute DNS server that is used by this Zone.