User’s Manual of WGR-500-4P and WGR-500-4PV
52
4.3.1 WAN Setup
This page is used to configure the parameters for Internet network which connects to the WAN port of industrial
wall-mount Gigabit router as shown in
Figure 4-26
. Here you may change the access method to static IP, DHCP,
PPPoE, PPTP or L2TP by clicking the item value of WAN Access type.
Figure 4-26:
WAN Setup
Object
Description
WAN Access Type
Please select the corresponding WAN Access Type for the Internet, and fill
the correct parameters from your local ISP in the fields which appear below.
Static IP
Select Static IP Address if all the Internet ports’ IP information
is provided to you by your ISP (Internet Service Provider). You
will need to enter the IP address, subnet mask, gateway
address, and DNS address provided to you by your ISP.
Each IP address entered in the fields must be in the
appropriate IP form, which are four octets separated by a dot
(x.x.x.x). The Router will not accept the IP address if it is not
in this format.
IP Address
Enter the IP address assigned by your ISP.
Subnet Mask
